2002 Bombardier Traxter Factory Service Manual, Page 235Get this manual
Section 09 BRAKES Subsection 02 (HYDRAULIC BRAKES)
Installation
For the installation, reverse the removal procedure, paying attention to the following detailsFront Brakes Place the brake lever assembly no4 on the handlebarPosition cylinder holding bracket with the UP mark upwardInstall bolts and tighten looselyWith the handlebar in straight ahead position, position cylinder reservoir parallel to the groundTighten upper bolt in first
CALIPER
Removal
Loosen wheel nutsRaise vehicle and support it securelyRemove wheel(s)Remove Banjo bolt no9 with sealing washers no10 and detach brake hose from caliperCatch spilled fluid with ragUnscrew bolts no25 retaining caliper to knuckle and remove caliper2 1
V01K13A
TYPICAL