2002 Bombardier Traxter Factory Service Manual, Page 184Get this manual
Section 06 DRIVE TRAIN Subsection 02 (FRONT DRIVE)
Installation
Apply grease (PN 293 550 019) to the splines and insert the end of drive shaft in differential and pull joint little to make sure that the stop ring is locked in differential side gear groove
V01H0FA
V01H0XA
1Stop ring
Insert the other end of drive shaft in the knuckle and install the knuckle, with hub and disk brake, to the lower and upper suspension armTorque the castellated nuts to 50 Nm (37 lbfft) and install new cotter pinReinstall tie-rodPlace washer on the top and the other between knuckle and castellated nutTorque to 70 Nm (52 lbfft) then install new cotter pinInstall the O-ring, the flat washer and torque the castellated nut on the drive shaft end to 140 Nm (103 lbfft) minimumInstall new cotter pin and the wheel capReinstall the front wheel(s) and torque nuts to 75 Nm (55 lbfft)