2002 Bombardier Traxter Factory Service Manual, Page 160Get this manual
Section 05 ELECTRICAL Subsection 06 (HYDRAULICELECTRIC SHIFT SYSTEM)
Task 2: Clutch Modulator Calibration
NOTE: When the number of the clutch modulator calibration is selected, an automatic calibration mode is activatedIt is possible to change the calibration manually by performing the following instructionsThe clutch modulator will be manual until the number is selected againThe LED "Check Engine" blinks for maximum time of seconds or until the user begins the calibration process or removes the jumper
The upshiftdownshift button is used to change the calibration of the clutch modulator valveWhen one of these buttons is activated, the LED "Check Engine" stops to blink and goes ONThe corresponding LEDS are turned ON according to the calibration (see table below)Table 1: Corresponding Clutch Modulation Calibration