2002 Bombardier Traxter Factory Service Manual, Page 152Get this manual
Section 05 ELECTRICAL Subsection 05 (IGNITION SYSTEM)
Trigger Coil
NOTE: The trigger coil is not adjustableSTATIC TEST: CONTINUITY Check resistance with high-sensitivity ohmmeter1Disconnect the Deutsch 6-pin connector at engine2Install the 6-pin magneto harness adapter (PN 295 000 136)
DYNAMIC TEST 1Disconnect magneto wiring harness connector2Install the 6-pin magneto harness adapter (PN 295 000 136)3Connect one of the multimeter leads to the WHITEYELLOW wire of the 6-pin magneto harness adapter4Connect the other multimeter lead to the BLACK YELLOW wire of the 6-pin magneto harness adapter5Remove the ignition fuse and press STARTSTOP button, note resultThe obtained value should be between 0.4 and 0.7 Vac6If the trigger coil is out of specification, replace itIf it tests good continue the other tests