2002 Bombardier Traxter Factory Service Manual, Page 147Get this manual
Section 05 ELECTRICAL Subsection 04 (STARTING SYSTEM)
StartStop Switch
If engine does not turn when pressing the start stop button, test the switch as followsRemove steering cover and unplug the multifunction switch connectorElectric Starter
NOTE: Starter is located behind LH side panelRemove LH side panel to give access to the starterRefer to BODYUsing boosting cables, carefully supply current from the battery directly to the starterConnect the BLACK negative cable firstThen connect the remaining jump cable from the starter then to the batteryIf starter now turns ensure the cablesconnections from battery to solenoid and to starter are in good conditionIf they test good, the MPEM can be suspectedSee MPEM belowIf starter does not turn, check for mechanical problems in the starter
V01G0TA
1Unplug connector 2RED wiring harness
Using multimeter, measure the resistance between the following wiresPOSITION Switch released Switch depressed and held WIRE BLACK and YELLOW RESISTANCE Infinite (0.L) 0.4 max