2002 Bombardier Traxter Factory Service Manual, Page 93Get this manual
Section 03 ENGINE Subsection 10 (CRANKSHAFTBALANCER SHAFT)
CAMSHAFT BORE mm (in) SERVICE LIMIT Clutch housing Magneto housing 32.036 (1.261) 18.035 (.71)
Subtract the camshaft end diameter from the proper bore diameter to find clearanceCAMSHAFT END CLEARANCE mm (in) SERVICE LIMIT Clutch side Magneto side 0.086 (.0034) 0.075 (.0029)
the second section of shifting system (refer to TRANSMISSION) starter, water pump, magneto and ring gear (refer to MAGNETO SYSTEM) all bolts and socket screws retaining crankcaseSeparate crankcase housingsRemove balancer shaft
Inspection
Check balancer shaft bearing in the front and rear housing for excessive play and smooth operationReplace if necessary
Installation
For installation, reverse the removal procedureDo not forget, to align the camshaft gear dot with the control gear dot as well as the dot on crankshaft gear with the balancing shaft gear dot
If necessary, change camshaft andor camshaft housing andor crankcase