2002 Bombardier Traxter Factory Service Manual, Page 74Get this manual
Section 03 ENGINE Subsection 07 (MAGNETO SYSTEM)
GENERAL
To reach any parts of the magneto system, the engine removal is not necessaryAt installation, use torque values and Loctite products from the exploded viewClean threads before using Loctite products when installing screws
Remove: rear swing arm and rear propeller shaft (refer to REAR AXLE) water pump housing (refer to COOLING SYSTEM) GBPS (Gear Box Position Sensor)
MAGNETO HOUSING COVER
Removal
Place the vehicle on jack stands and place the shifter on NEUTRAL positionRemove seat then remove batteryDisconnect BLACK (-) cable from battery, then RED (+) cable
WARNING
Always disconnect battery or starter cables exactly in the specified order, BLACK (-) cable firstV01C2IA
Drain engine oil and engine coolant by removing drain plugs