2002 Bombardier Quest 650XT Service Manual, Page 293Get this manual
Section 10 BODYFRAME Subsection 02 (BODY)
INSTALLATION ON PLASTIC Clean surface with isopropyl alcoholUsing pencil and the decal as template, mark the area where decal will be locatedApply an activator (PN 293 530 036) to prepare the surface using clean clothAfter few seconds, when the activator evaporates, the surface is readyCAUTION: Do not use soapy water to locate decal on plastic partsRemove back protective film from decal and carefully align decal with marksWhen well aligned squeegee decal beginning at center and working outward using firm, short, overlapping strokes
PLASTIC REPAIR REPAIR
The very first step before repairing plastic materials is to find out exactly which type of material is involvedRefer to following chartCAUTION: Consult the plastic maintenance chart carefully, some maintenance products are not compatible with certain plasticsIRREPARABLE PART Fuel tank cover Front facia Front and rear fender Rear fender cover Footrest Steering cover Storage cover Inner fender Front skid plate Console CVT cover heat shield Engine side panels Front and rear mudguard Rear facia