2002 Bombardier Quest 650XT Service Manual, Page 292Get this manual
Section 10 BODYFRAME Subsection 02 (BODY)
SEAT COVER REPLACEMENT
Remove the old seat cover no64Check the foam and replace if necessaryInstall staples with an electric tacker such as Arrow tacker noETN-50 or with manual tacker such as Arrow tacker noT-50NOTE: For an easier installation, it's highly recommended to use an electric tackerEnsure that the seat rest firmly against hard surface such as piece of woodThis is done to get the staples completely pushed in place
SEAT CLEANING
It is recommended to clean the seat with solution of warm soapy water, using soft clean clothCAUTION: Avoid use of harsh detergents such as strong soaps, degreasing solvents, abrasive cleaners, paint thinners, etcthat may cause damage to the seat cover
DECALS REPLACEMENT
Removal
Using heat gun warm up one end of decal for few seconds until decal can roll off when rubbing with your fingerPull decal slowly and when necessary apply more heat to ease removal on the area that has to be peeled offIf decal tears while pulling off, it has to be heated for few seconds longerIf decal tends to stretch while pulling off, stop heating and wait few seconds to let it cool, then peel it off