2002 Bombardier Quest 650XT Service Manual, Page 269Get this manual
Section 09 BRAKES Subsection 02 (HYDRAULIC BRAKES)
Assembly
Coat piston seal with clean brake fluid and install it into piston grooves in caliperCoat piston with clean brake fluid and install into cylinder with the closing toward caliper bodyApply silicone grease into sliding bores and install slide pinsNOTE: Make sure that rubber boots are correctly installed in slide pins groovesInstall pad spring, caliper bracket and pads
Installation
For the installation, reverse the removal procedure, paying attention to the following detailsUse new sealing washers when installing Banjo bolt retaining brake hose to caliperInstall caliper to knuckleIf hose was disconnected, bleed the brakesCheck for leaks and make sure the brakes operate normally before driving
V04K0CA
TYPICAL 1Remove Banjo bolt and washers 2Unscrew bolts 3Brake hose
Disassembly