2002 Bombardier Quest 650XT Service Manual, Page 268Get this manual
Section 09 BRAKES Subsection 02 (HYDRAULIC BRAKES)
Connect brake hose to master cylinder with bolt and new sealing washersBleed front brake systemCheck for leaks and make sure the brakes operate normally before drivingRear Brake Install master cylinder to frameInstall rear brake hose to master cylinder using new sealing washersConnect flexible hose from reservoir and secure with new locking tieFill up reservoir with clean brake fluidCAUTION: Do not mix different types of brake fluidUse only DOT brake fluidBleed rear brake systemCheck for leaks and make sure the brakes operate normally before drivingConnect brake light switch connectors
V04K0BA
A101 mm (3.976 132 in)
Installation
For the installation, reverse the removal procedure, paying attention to the following detailsFront Brakes Place the brake lever assembly no4 on the handlebarPosition cylinder holding bracket with the UP mark upwardInstall bolts and tighten looselyWith the handlebar in straight ahead position, position cylinder reservoir parallel to the groundTighten upper bolt in first