2002 Bombardier Quest 650XT Service Manual, Page 177Get this manual
Subsection 03
Section 04 FUEL SYSTEM (CARBURETOR AND FUEL PUMP)
Refer to following photos for proper float level gauge positioningNOTE: Refer to TECHNICAL DATA for proper levelTo adjust height, bend the contact tab of float arm until the specified height is reachedCAUTION: When adjusting contact tab, do not pry onThis would apply pressure on needle and damage valve seatneedle
Installation
To install carburetor on engine, inverse removal procedure, as described: Inspect throttle and choke cable housing prior to installation Reinstall throttle and choke cables, at the same time adjust the throttle cable, then install the side coverRefer to CARBURETOR ADJUSTMENTS below in this section Reinstall carburetor on engineWhen reinstalling carburetor on engine, pay attention to the following: CAUTION: The rubber flanges must be checked for cracks andor damageAt assembly, the rubber flanges must be perfectly matched with the air box, carburetor and engine or severe engine damage will occurDo not use screwdriver or other tool to install the rubber flangesInstall rubber flange on air box side so that its recess aligns with air box notch, as shown in the next photoCallout