2002 Bombardier Quest 650XT Service Manual, Page 139Get this manual
Section 03 ENGINE Subsection 10 (GEARBOX)
For ball bearing no60, remove screw no46 then push bearing from outside in with punch
Bearing Installation Procedure Unless otherwise instructed, never use hammer to install ball bearings, needle bearings or plain bearingsUse press machine onlyAlways heat crankcase housing up to 100C (212F) before installing ball bearings, needle bearings or plain bearings
WARNING
Clean oil, outside and inside, from housing before heatPlace new bearing in freezer for 10 minutes before installationInstall plain bearings no42, no43, no44 and no45 with the proper plain bearing installerNOTE: Place the proper crankcase support under crankcase before install plain bearingsR610motr164A