2002-2003 Bombardier Baja DS650 Service Manual, Page 201Get this manual
Section 10 BODYFRAME Subsection 02 (BODY)
Installation
There are types of decals used on ATV'sOne has protective film on back side and the other has protective film on both sidesThey are used on types of materials; plastic and metalDECALS HAVING PROTECTIVE FILM ON BACK SIDE ONLY These decals usually contain written information (ex warning)Clean surface with good solvent such as ACRYLICLEAN DX 330 from PPG or equivalent (refer to manufacturer instructions)Using pencil and the decal as template, mark the area where decal will be locatedRemove half of the decal back protective film and align decal with marksStart sticking it from center and remove the other half of the film to stick it completelyCarefully squeegee decal beginning at center and working outward using, firm, short, overlapping strokesDECALS HAVING PROTECTIVE FILM ON BOTH SIDES These decals usually contain graphicsINSTALLATION ON PLASTIC Clean surface with isopropyl alcoholUsing pencil and the decal as template, mark the area where decal will be locatedApply an activator (PN 293 530 036) to prepare the surface using clean clothAfter few seconds, when the activator evaporates, the surface is readyCAUTION: Do not use soapy water to locate decal on plastic partsRemove back protective film from decal and carefully align decal with marksWhen well aligned squeegee decal beginning at center and working outward using firm, short, overlapping strokes