2002-2003 Bombardier Baja DS650 Service Manual, Page 186Get this manual
Section 09 BRAKES Subsection 02 (HYDRAULIC BRAKES)
NOTE: Check fluid level often to prevent air from being pumped into the systemRepeat the procedures until air bubbles don't appear in bleed hoseNOTE: For the front brake system, switch to LH and RH caliperTurn handle bar to full RH side when bleeding right caliper no6 and turn to the LH side for the left caliper no7This helps the bleeder to reach air into the caliperClose bleed valves and operate brake lever no4 or brake pedal no5If it still feels spongy, bleed system againFill reservoir to the upper level with DOT brake fluidInstall diaphragm and cover on reservoirIf brake bleeder is not available, use the following procedureInstall tube to bleed valveOpen bleederFill reservoir and pump lever until fluid freely flows out of the tubeClose bleed valvePump up system pressure with brake lever or brake pedal until lever or pedal resistance is feltSqueeze brake lever or depress brake pedal, open bleed valve and then close itNOTE: Do not release brake lever or brake pedal until bleed valve has been closedFor the front brake system, switch to LH and RH caliperTurn handle bar to full RH side when bleeding right caliper no6 and turn to the LH side for the left caliper no7This helps the bleeder to reach air into the caliperRelease brake lever or brake pedal slowlyRepeat the procedures until air bubbles don't appear in tube and lever or pedal is stiff