2002-2003 Bombardier Baja DS650 Service Manual, Page 151Get this manual
Section 06 DRIVE TRAIN Subsection 02 (FRONT DRIVE)
GENERAL
For installation, use the torque values and Loctite products from the exploded viewsClean threads before using Loctite when installing the screws
WHEEL HUB BEARING
Inspection
Check inner race of each bearing no2 with fingerThe bearing should turn smoothly and quietlyCheck if bearing outer race fits tightly in the hubRemove and discard bearings if races do not turn smoothly and quietly or if they fit loosely in hubReplace bearings and hub if bearings fit loosely into hubNOTE: Replace wheel hub bearings in pairsDo not reuse old bearings
WARNING
Torque wrench tightening specifications must strictly be adhered toLocking devices (ex locking tabs, elastic stop nuts, self-locking fasteners, etc must be installed or replaced with new ones where specifiedIf the efficiency of locking device is impaired, it must be renewed
Removal
Remove seal no8 (discard)Place wheel hub in viseInsert punch into the inside bushing no9Place the end of punch on the inside bushing lips and drive bearing out of wheel hub