2001 Bombardier DS 650 Shop Manual 704 100 011, Page 168Get this manual
Section 10 BODYFRAME Subsection 02 (BODY)
Ensure that the seat rest firmly against hard surface such as piece of woodThis is done to get the staples completely pushed in place
If decal tears while pulling off, it has to be heated for few seconds longerIf decal tends to stretch while pulling off, stop heating and wait few seconds to let it cool, then peel it off
Installation
There are types of decals used on ATVOne has protective film on back side and the other has protective film on both sidesThey are used on types of materials; plastic and metalDECALS HAVING PROTECTIVE FILM ON BACK SIDE ONLY These decals usually contain written information (ex warning) and are used on metalClean surface with good solvent such as ACRYLICLEAN DX 330 from PPG or equivalent (refer to manufacturer instructions)Using pencil and the decal as template, mark the area where decal will be locatedRemove half of the decal back protective film and align decal with marksStart sticking it from center and remove the other half of the film to stick it completelyCarefully squeegee decal beginning at center and working outward using, firm, short, overlapping strokesDECALS HAVING PROTECTIVE FILM ON BOTH SIDES These decals usually contain graphics and are used on plasticINSTALLATION ON PLASTIC Clean surface with isopropyl alcoholUsing pencil and the decal as template, mark the area where decal will be locatedApply an activator (PN 293 530 036) to prepare the surface using clean clothAfter few seconds, when the activator evaporates, the surface is readyCAUTION: Do not use soapy water to locate decal on plastic partsRemove back protective film from decal and carefully align decal with marksWhen well aligned squeegee decal beginning at center and working outward using firm, short, overlapping strokesF01L3YA