2001 Bombardier DS 650 Shop Manual 704 100 011, Page 156Get this manual
Section 09 BRAKES Subsection 02 (HYDRAULIC BRAKES)
Inspection and Lubrication
Discard any remaining fluid inside reservoirClean reservoirs, master pistons and master cylinders thoroughly with clean brake fluidCheck: boots for crack springs for damage piston cups for wear, deterioration or damage master cylinders and pistons for scoring, scratches or other damageChange part(s) if necessaryCheck locking pin no26 for excessive wear, replace if necessaryNOTE: If master cylinder is damaged or leaking, replace as an assemblyV02K07A
A3 mm (18 132 in)
Installation
For the installation, reverse the removal procedure, paying attention to the following detailsFront Brakes Place the master cylinder no8 on the handlebarPosition cylinder holding bracket with the UP mark upwardInstall bolts and tighten looselyWith the handlebar in straight ahead position, position cylinder reservoir parallel to the groundTighten upper bolt in first then lower bolt