1999-2000 Bombardier Traxter ATV Factory Service Manual, Page 183Get this manual
Section 08 SUSPENSION Subsection 03 (REAR SUSPENSION)
Remove M10 nuts and bolts retaining swing arm to rear axle tube
Installation
Installation is essentially the reverse of removal procedureHowever, pay attention to the following detailsSecure rear rigid axle center section to swing arm with socket screwsApply sealant Right Stuff (PN 293 800 053) between both partsDo not tighten yetSecure rear axle tube to swing arm with boltsDo not tighten yetWhen all bolts are installed, tighten in criss-cross sequence
V01J06A
1Remove nuts and bolts
Detach swing arm no9 from rear drive system assembly