1999-2000 Bombardier Traxter ATV Factory Service Manual, Page 142Get this manual
Section 05 ELECTRICAL Subsection 06 (ELECTRIC SHIFT SYSTEM)
SENSOR REMOVALINSTALLATION
CAUTION: It is recommended to always disconnect the battery when replacing any electric or electronic part(s)
Installation
For installation, reverse the removal procedurePay attention to the following details: Check O-ring and change if necessary Align interior of GBPS and engine shaft Place connector on topSecure with screws and lock washersApply Loctite 242 on threads Torque screws to Nm (27 lbfin) Calibrate GBPSRefer to DIAGNOSTICCALIBRATION MODE section, task 4
STPS (Sub-Transmission Position Sensor)
The STPS is located on front of engine
Refer to SENSORS TESTS section
Removal
Remove fuel tank coverRefer to BODY 10-02Remove seat pivot barUnplug STPSRemove screws and lock washers retaining STPS on enginePull STPS
VSS (Vehicle Speed Sensor)
The VSS is located on front of engine