1999-2000 Bombardier Traxter ATV Factory Service Manual, Page 91Get this manual
Section 04 FUEL SYSTEM Subsection 03 (CARBURETOR AND FUEL PUMP)
Separate cable end bushing from throttle cable end, as shown in the next photoKeep bushing
Carburetor body and jets should be cleaned in carburetor cleaner following manufacturer's instructions
WARNING
Solvent with low flash point such as gasoline, naphtha, benzol, etc should not be used as they are flammable and explosive
CARBURETOR FLOAT LEVEL ADJUSTMENT
Correct fuel level in float chamber is vital toward maximum engine efficiencyTo check for correct float level proceed as follows: Remove float bowl and gasket from carburetor Make sure that float arm is symmetric-not distoredWith carburetor chamber up side down: Measure height between bowl seat and the top edge of float armUse float level gauge (PN 529 035 520) Keep float level gauge perfectly vertical and in line with main jet holeEnsure that both float level gauge tips are properly positioned on carburetor body and that "L" arm is leaning on float without compressing valve springRefer to following photos for proper float level gauge positioning