1999-2000 Bombardier Traxter ATV Factory Service Manual, Page 53Get this manual
Section 03 ENGINE Subsection 04 (REWIND STARTER)
CAUTION: The use of standard multi-purpose grease could result in rewind starter malfunctionTo install new rope no5, insert rope into sheave orifice and lock it with the key no4 as illustrated
V01C0ZA
V01C10A
TYPICAL 1Spring coated with MOLYKOTE G-n paste
TYPICAL 1Push to lock
Install locking ringCAUTION: This lubricant must NOT be used on rewind springs as it does not stay on when dry
To adjust rope tension: Wind rope on sheave and place rope sheave into starter housing making sure that the sheave hub notch engages in the rewind spring hookRotate the sheave counterclockwise until rope end is accessible through starter housing orificePull the rope out of the starter housing and temporarily make knot to hold itOne turn preload will give turns of tension when fully extended