1999-2000 Bombardier Traxter ATV Factory Service Manual, Page 52Get this manual
Section 03 ENGINE Subsection 04 (REWIND STARTER)
REWIND STARTER
Removal
Remove fuel tank cover and skid plateRefer to BODY 10-02Remove seat pivot bar and unplug clutching and clutch modulator valve connectorRemove rewind mounting bolts no15 and pull rewing starterDisassembly
To remove rope from rewind starter mechanism: First remove flat washer and screw no10 and 11, locking spring no9, locking spring washer no8, pawl lock no7 and pawl no6 Remove sheave no3 from starter housing no1 Disengage key no4 and pull out rope no5V01C0WA
TYPICAL 1Outer end into guide notch
NOTE: Due to dust accumulation, rewind starter must be periodically cleaned, inspected and relubricatedCAUTION: It is of the utmost importance that the rewind starter spring(s) be lubricated periodically using specific lubricantsOtherwise, rewind starter component life will be shortened andor rewind starter will not operate properly under very cold temperaturesLubricate spring assembly with silicone compound grease (PN 420 897 061) and position into starter housing as illustratedCAUTION: This lubricant must NOT be used on rewind starter locking spring as it does not stay on under vibration1