2011 Arctic Cat Prowler XT/XTX/XTZ ATV/ROV Service Manual, Page 217Get this manual

NOTE: During assembling, new cotter pins should be installed 4Apply small amount of grease to the hub splines

NOTE: If the hole in the axle shaft does not align with the slots in the castle nut, tighten the nut until the hole and slots alignPR290A

5Install the hub assembly onto the splines of the shaft
8Secure the brake caliper to the knuckle with the two new "patch-lock" cap screwsTighten to 20 ft-lb

• ATV
• Jet Ski
• Outboard Motors
• Personal Watercraft
• Snowmobiles
• Stern Drives