2011 Arctic Cat Prowler XT/XTX/XTZ ATV/ROV Service Manual, Page 216Get this manual
6Remove the cotter pin from the tie rod end and remove the tie rod end from the knuckle7Remove the two cap screws securing the ball joints in the knuckle PR292A
8Tap the ball joint end out of the knuckle; then remove the knuckle9Remove the snap ring securing the bearing in the knuckle; then press the bearing out of the knuckle
2Install the knuckle to the upper and lower ball joints and secure with the two cap screwsTighten to 35 ft-lb