2011 Arctic Cat Prowler XT/XTX/XTZ ATV/ROV Service Manual, Page 202Get this manual
6Install new cotter pin and spread the pin to secure the nutNOTE: If the cotter pin can not be inserted due to misalignment of the hole in the axle and the slots in the nut, tighten the nut until properly aligned PR220A
NOTE: Never reuse lock nutOnce lock nut has been removed, it must be replaced with new lock nut
9Remove the cap screws and lock nuts securing the A-arms to the frame; then remove the A-arms
CLEANING AND INSPECTING
NOTE: Whenever part is worn excessively, cracked, or damaged in any way, replacement is necessary
7Secure the shock absorber to the frame with cap screw and new lock nutTighten to 33 ft-lb8Secure the shock absorber to the lower A-arm with cap screw and new lock nutTighten to 20 ft-lb9Secure the boot guard to the lower A-arm with the two cap screwsTighten securely10Install the wheel and tighten to 80 ft-lb (aluminum wheels) or 45 ft-lb (steel wheels)11Remove the vehicle from the support stand
1Clean all A-arm components in parts-cleaning solvent2Inspect the A-arm for bends, cracks, and worn bushings3Inspect the frame mounts for signs of damage, wear, or weldment damage