2011 Arctic Cat Prowler XT/XTX/XTZ ATV/ROV Service Manual, Page 193Get this manual
7Place new crush washer on each side of the brake hose fitting and install it on the caliperTighten to 20 ft-lb8Fill the reservoir; then bleed the brake system (see Section 2) ! WARNING
Never use brake fluid from an open container or reuse brake fluidMoisture-contaminated brake fluid could cause vapor build-up (expansion) during hard braking resulting in greatly increased stopping distance or loss of control leading to injury or death
9Install the wheelTighten to 80 ft-lb (aluminum wheels) or to 45 ft-lb (steel wheels)10Remove the vehicle from the support stand and verify brake operation
3Remove the oil bolt securing the banjo-fittings to the master cylinder; then remove the master cylinderDiscard the three crush washers
MASTER CYLINDER ASSEMBLY
NOTE: The master cylinder is non-serviceable component; it must be replaced as an assembly
CAUTION