2011 Arctic Cat Prowler XT/XTX/XTZ ATV/ROV Service Manual, Page 188Get this manual
Hub REMOVING
1Secure the vehicle on support stand to elevate the wheel; then remove the wheelNOTE: Removing or tightening of the hub nuts requires the axles be lockedTo lock the rear axle, set the parking brakeTo lock the front axle, turn the ignition switch to ON, select LOCK on the drive select switch; then set the parking brake and turn the ignition switch to OFF
4Install the clutch basket (XTZ) onto the input shaft and secure with the snap ring (flat side directed outward); then install the clutch pack into the basket
! WARNING
Make sure the vehicle is solidly supported on the support stand to avoid injury
2Remove the cotter pin from the axleNOTE: During assembly, new cotter pins should be installed