2011 Arctic Cat Prowler XT/XTX/XTZ ATV/ROV Service Manual, Page 172Get this manual
4Install the input shaft into the pinion housing; then secure in the bearing with circlip GC015
5Place the pinion housing with new gasket onto the differential housing; then secure with existing cap screwsTighten to 23 ft-lbNOTE: If new differential housing is being installed, tighten the cap screws to 28 ft-lb
2Using T-40 torx wrench, remove the cap screws securing the differential coverAccount for and make note of the ID tag location for assembling purposes
3Using plastic mallet, tap lightly to remove the differential coverAccount for an O-ringKX209