2011 Arctic Cat Prowler XT/XTX/XTZ ATV/ROV Service Manual, Page 162Get this manual
2Install the needle adapters to the multimeter leads; then select DC Voltage on the multimeter3Connect the red tester lead to the bluebrown wire (B) and the black tester lead to the blackyellow wire (A); then turn the ignition switch ON and observe the meterThe meter should read 0.8-3.0 DC volts Throttle Position Sensor (TPS)
INSPECTING
1Remove the seats and center console; then disconnect the three-wire TPS connector plug
4Tilt the sensor 60 or more to the left and right observing the meterThe meter should read 4.0-8.0 DC volts after approximately one second in the tilted positionIf the meter readings are not as specified, the tilt sensor is defective
NOTE: Prior to testing the TPS, inspect the three-wire plug connector on the main harness and the three-pin plug on the TPS for contamination, broken pins, andor corrosion