2011 Arctic Cat Prowler XT/XTX/XTZ ATV/ROV Service Manual, Page 161Get this manual
2632344041609596979899 =
Ignition Coil #2H2 Fuel Injector #1 Fuel Injector #2H2 ISC (Idle Speed Control) Valve Fuel Pump Relay Cooling Fan Relay Sensor Power Incorrect ECU ECU Memory Power (constant battery power) ECU to Gauge Comm LinkH2 StartRun Not Possible (active code only)
Will initiate code 99
After all stored codes are cleared, clear the error code(s) using the following procedureNOTE: The ignition switch should be in the OFF position
2Turn the ignition switch to the ON positionThe multimeter should read battery voltageIf battery voltage is not indicated, check the 30-amp fuse, wiring harness, or the ignition switch3Remove the red tester lead and connect to the bluebrown wire (B)The multimeter should read approximately 2.5 DC voltsIf the specified voltage is not indicated, check wire connections at the ECU or substitute another ECU to verify the test
1With the test plug connected to the diagnostic plug and the drive select switch in the 4WD position, hold the reverse override switch down and turn the ignition switch to the ON position2After ten seconds, release the reverse override switch and turn the ignition switch to the OFF position; then turn the ignition switch to the ON positionThe display should read AC00 (no fault detected)NOTE: If the LCD still displays an error code, continue troubleshooting the appropriate component