2011 Arctic Cat Prowler XT/XTX/XTZ ATV/ROV Service Manual, Page 157Get this manual
Stator CoilCrankshaft Position (CKP) Sensor VOLTAGE (AC Generator Regulated Output)
1Set the meter selector to the DC Voltage position2Connect the red tester lead to the positive battery post; then connect the black tester lead to the negative battery post3With the engine running at constant 5000 RPM (with the headlights on), the meter must show 14-15.5 DC volts
2Connect the black lead to the black wire using MaxiClip; then select 2WD on the drive select switch
CAUTION
Do not run the engine at high RPM for more than 10 seconds
NOTE: If voltage is lower than specified, test AC GeneratorNo Load
VOLTAGE (AC GeneratorNo Load)