2011 Arctic Cat Prowler XT/XTX/XTZ ATV/ROV Service Manual, Page 155Get this manual
NOTE: Prior to troubleshooting below, make sure that Ignition Key Switch has not been left on with the engine not startedAfter five minutes, this will deactivate the EPS and display the malfunction codeTurn Ignition Key Switch OFF and back to ON to reset and reactivate the EPSIf code and symptom persists, continue as follows:
Ignition Switch
To access the ignition switch, dash switches, front accessory connectors, and front switched accessory connector, the dash must be unfastened and slid to the rear
1Check 30 amp EPS fuse2Check EPS relay (may be switched with any other 4-pin relay on PDMreplace relay if EPS normal after switching)3Disconnect 2-pin connector on the EPS assembly and connect volt meter set to DC voltage to the harness (black meter lead to BLK and red meter lead to ORGBRN) With the ignition switch to the ON position, the meter must read more than 8.5 DC volts (if correct voltage is not present, check connections and wiring harnessif correct voltage is present, replace EPS assemblysee Section 8)