2011 Arctic Cat Prowler XT/XTX/XTZ ATV/ROV Service Manual, Page 153Get this manual
NOTE: If the meter does not read as specified, replace the sensor Speed Sensor
NOTE: Prior to testing the speed sensor, inspect the three-wire connector on the speed sensor for contamination, broken pins, andor corrosionAR603D
1Set the meter selector to the DC Voltage position2With appropriate needle adapters on the meter leads, connect the red tester lead to the voltage lead (V); then connect the black tester lead to the ground lead (G)
2The meter reading must be within specificationNOTE: If the meter does not show as specified, replace the spark plug cap
VOLTAGE Primary Coil
1Set the meter selector to the DC Voltage position; then disconnect the two wires from the coilNOTE: The coil is located to the right of the engine and may be accessed from behind the right-side seat with the cargo box raised
2Connect the red tester lead to the orange wire and the black tester lead to the bluewhite wire (H1) or to ground (H2)3Turn the ignition switch to the ON positionThe meter must show battery voltage3Turn the ignition switch to the ON position