2011 Arctic Cat Prowler XT/XTX/XTZ ATV/ROV Service Manual, Page 150Get this manual
Switches Each time the vehicle is used, switches should be checked for proper operationUse the following list for referenceAIgnitionstart switch engine will run; starter will engageBDrive select switch differential will engage (4WD)disengage (2WD)CReverseneutralhighlow switch RNHL will be indicated on the LCDDHeadlight switch high beam, low beam, and lights off can be selectedEBrake switch brakelight illuminates and starter can be engaged with vehicle in gear
NOTE: The ignition switch must be in the ON position
VOLTAGE (Wiring Harness Connector)
1Set the meter selector to the DC Voltage position2Connect the red tester lead to the orange wire; then connect the black tester lead to ground
Electrical Connections
The electrical connections should be checked periodically for proper functionIn case of an electrical failure, check fuses, connections (for tightness, corrosion, damage), andor bulbs