2011 Arctic Cat Prowler XT/XTX/XTZ ATV/ROV Service Manual, Page 149Get this manual
5Add clean distilled water to bring fluid level to the UPPER level line ! WARNING
Battery acid is harmful if it contacts eyes, skin, or clothingCare must be taken whenever handling battery
9Connect the multimeter and test the battery voltageThe meter should read at least 12.5 DC VoltsIf the voltage is as specified, the battery is ready for serviceNOTE: If voltage in step is below specifications, charge the battery an additional 1-5 hours; then retestRecheck electrolyte level and the battery is ready for service
CAUTION
Never use electrolyte (sulfuric acid) to "top off" the batteryUse only distilled water or severe battery damage may occur
10Place the battery in the battery compartment; then coat the battery posts and cable ends with light coat of multi-purpose grease
6Using multimeter, test the battery voltageThe meter must read at least 12.5 DC Volts for fully charged batteryNOTE: At this point, if the meter reads as specified, the battery may be returned to service (see step 10)
CAUTION
Before installing the battery, make sure the ignition switch is in the OFF position