2011 Arctic Cat Prowler XT/XTX/XTZ ATV/ROV Service Manual, Page 145Get this manual
CAUTION Take care not to damage the float or float arm or replacement of the entire assembly will be necessary
4To replace the fuel level sensor, use the following procedureADisconnect the two-wire connector (A); then press the fuel level sensor toward the top of the fuel pump to release it from the mounting slot (B)
5Using duct tape or other suitable means, cover the fuel pump opening
INSPECTING
AT THIS POINT
If the pump has failed earlier test and must be replaced, proceed to INSTALLING
1Inspect the fuel screen and blow clean with low pressure compressed air2Move the float lever and check for free movementThe float assembly should return to the lower position without forceIf not, replace the fuel level sensor assembly3Test the fuel level sensor by connecting multimeter (A) to the fuel level sensor leads (B); then select OHMSThe multimeter should show ohms at full fuel position (C) and 95 ohms at empty fuel position (D)