2011 Arctic Cat Prowler XT/XTX/XTZ ATV/ROV Service Manual, Page 144Get this manual
2Install the water pump assembly onto the engine aligning the flat drive on the water pump to the slot in the driveshaft 1Turn the ignition switch ON and listen for momentary "whirring" sound of the pump building pressureIf the sound is heard (10 seconds), no electrical checks are necessaryTurn the ignition switch OFF2Disconnect the gasline hose from the fuel rail; then install suitable pressure gauge
! WARNING
Gasoline may be under pressurePlace an absorbant towel under the connector to absorb any gasoline spray when disconnecting
CAUTION
Do not force the water pump housing into the crankcase or sever engine damage may occur
3Secure the water pump with the two cap screws and tighten securely; then connect the coolant hoses and secure with hose clamps4Tighten the coolant drain plug securely; then fill the cooling system with appropriate mixed coolant and install the radiator cap5Start the engine and check for coolant leaks; then add coolant if necessary to proper levelFI092A