2011 Arctic Cat Prowler XT/XTX/XTZ ATV/ROV Service Manual, Page 141Get this manual
Thermostat REMOVING
1Drain approximately one quart of coolant from the cooling system2Remove the two cap screws securing the thermostat housing to the cylinder headAccount for thermostat with seal
INSPECTING
NOTE: Whenever part is worn excessively, cracked, or damaged in any way, replacement is necessary
2Fill the cooling system with the recommended amount of antifreezeCheck for leakage
1Inspect the thermostat for corrosion, wear, or spring damage2Using the following procedure, inspect the thermostat for proper operationASuspend the thermostat in container filled with waterBHeat the water and monitor the temperature with thermometerCThe thermostat should start to open at 71.0-86.0 (160-187 F)DIf the thermostat does not open, it must be replaced3Inspect all coolant hoses, connections, and clamps for deterioration, cracks, and wearNOTE: All coolant hoses and clamps should be replaced every four years or 4000 miles
Thermostat
REMOVING