2011 Arctic Cat Prowler XT/XTX/XTZ ATV/ROV Service Manual, Page 116Get this manual
NOTE: Continue to remove, measure, and install until backlash measurement is within toleranceNote the following chartBacklash Measurement Under 0.127 mm (0.005 in At 0.127-0.381 mm (0.005-0.015 in Over 0.381 mm (0.015 in
Shim Correction
Decrease Shim Thickness No Correction Required Increase Shim Thickness
3Once correct gear pattern and backlash are established, install new nut (coated with red Loctite #271) on the output shaft and tighten to 59 ft-lbPeen the nut to the shaftGZ396
3Firmly hold the bearing down and while rocking the drive bevel gear back and forth, note the maximum backlash reading on the gauge