2011 Arctic Cat Prowler XT/XTX/XTZ ATV/ROV Service Manual, Page 115Get this manual
3If installing the existing shaft, start with the shims removed during disassembly or if installing new shaft, start with approximately 1.0 mm shims at point (D); then install the output driveshaft bearing (E) making sure the locating pin is directed toward the center of the shaft
NOTE: Do not use new lock nut at this time as this procedure may have to be repeated
5Place the assembled shaft into the left crankshaft case; then lightly coat the gear teeth with machinist's lay-out dyeRotate the shafts through several rotations in both directionsGear contact should extend from the root to the top of the gear teeth
6To adjust tooth contact, use the following chart to correctly shim the driven shaftTooth Contact