2011 Arctic Cat Prowler XT/XTX/XTZ ATV/ROV Service Manual, Page 96Get this manual
APiston still at top-dead-centerBCamshaft lobes directed down (toward the piston)CCamshaft alignment marks parallel to the valve cover mating surfaceDRecessed side of the sprocket directed toward the cam lobesECamshaft alignment pin and sprocket alignment hole (smallest) are alignedGZ130
CAUTION
If any of the above factors are not as stated, go back to step 11 and carefully proceed
NOTE: At this point, oil the camshaft bearings, cam lobes, and the three seating journals on the cylinder
13With the cam lobes directed down (toward the piston), maneuver the camshaftsprocket assembly through the chain and towards its seating position; then loop the chain over the sprocketNOTE: Note the position of the alignment marks on the end of the camshaftThey must be parallel with the valve cover mating surfaceIf rotating the camshaft is necessary for alignment, rotate the sprocket inside the chain until the alignment pin can be engaged in the sprocket with the camshaft properly aligned to the head