2011 Arctic Cat Prowler XT/XTX/XTZ ATV/ROV Service Manual, Page 22Get this manual
5Verify that the park indicator light illuminates when the parking brake is set (igntion switch on) CheckingReplacing V-Belt
REMOVING
1Remove the seats and center console; then remove the left-side seat-base (XTXTX) or right-side seat base (XTZ)2Remove the cap screws securing the V-belt cover noting the location of the different-lengthed cap screws for installing purposes; then using rubber mallet, gently tap on the cover tabs to loosen the coverRemove the cover3Remove the nut securing the movable drive face; then remove the faceAccount for the flat washer and spacerNOTE: Keep the drive face plate in contact with the drive face when removing or installing the drive face to prevent the rollers from falling out
8Connect the brake cable to the actuator arm with the pin and flat washer and secure with the cotter pin; then adjust the parking brake (see ADJUSTING in this sub-section)
NOTE: Whenever installing new pads, the new pads must be burnished (see Burnishing Brake Pads in this section)