2011 Arctic Cat DVX 300 / 300 Utility ATV Service Manual, Page 101Get this manual
ASSEMBLING AND INSTALLING 1Remove any nicks or burrs from the bearing bosses in the cushion arm with fine emory cloth; then using suitable bearing installer, press new needle bearings into the end bosses of the cushion arm
7Apply grease to the swing arm pivot through the grease fittingKM565A
2If the bushing was removed from the middle boss of the cushion arm, press in new bushingNOTE: The bearings and bushing must be centered in the bearing boss so the dust seals can be properly installed
3Using an appropriate seal driver, install the new dust seals in the cushion arm; then apply multi-purpose grease to the bearings, bushing, and dust seal lips4Install the bushings in the cushion arm and cushion link; then connect the cushion link to the cushion arm with the flange cap screw and lock nutTighten securelyKM501