2011 Arctic Cat DVX 300 / 300 Utility ATV Service Manual, Page 76Get this manual
3The meter must show 50-60 ohmsNOTE: If the meter does not show as specified, troubleshoot or replace the connector or the fanNOTE: To determine if the fan motor is good, connect the blue wire from the fan connector to 12 volt DC power supply; then connect the black wire from the fan connector to groundThe fan should operate Fuses
1Set the meter selector to the OHMS position2Connect the red tester lead to one spade end of the fuse; then connect the black tester lead to the other spade end
! WARNING
Care should be taken to keep clear of the fan blades
Fuse Block
The fuses are located in fuse block under the seatIf there is any type of electrical system failure, always check the fuses firstNOTE: To remove fuse, compress the locking tabs on either side of the fuse case and lift out