2011 Arctic Cat 700 Diesel SD Service Manual, Page 146Get this manual
10Secure the shock absorber to the lower A-arm with cap screw and new lock nutTighten to 20 ft-lb11Secure the boot guard to the lower A-arm with the two cap screwsTighten securely12Install the wheel and tighten to 45 ft-lb13Remove the ATV from the support stand NOTE: Keep left-side and right-side wheels separated for installing them on their proper sides
CLEANING AND INSPECTING
NOTE: Whenever part is worn excessively, cracked, or damaged in any way, replacement is necessary
Wheels and Tires
KEY 123456789101112
1Thoroughly clean the wheels and hubs using pressure washer2Clean the tires with soap and water3Inspect each wheel for cracks, dents, or bends
Screw Brake Disc Wheel HubFront Hub Stud Wheel HubRear Hex Nut Cotter Pin Wheel Mounting Nut Tire Valve Stem Valve Stem Cap 0741-559
4Inspect each tire for cuts, wear, missing lugs, and leaksINSTALLING Install each wheel on its hubTighten to 45 ft-lbNOTE: Make sure each wheel is installed on its proper hub as noted in removing (the "rotation arrow" (if applicable) must indicate forward direction of rotation)