2011 Arctic Cat 700 Diesel SD Service Manual, Page 115Get this manual
3With the dimmer switch in the LO position, test the two outside connectors (LO beam)The meter must show battery voltage4With the dimmer switch in the HI position, test the two inside connectors (HI beam)The meter must show battery voltageNOTE: If battery voltage is not shown in any test, inspect the fuses, battery, main wiring harness, connectors, or the left handlebar switch 2Connect the red tester lead to the redblue wire; then connect the black tester lead to the black wire3With either brake applied, the meter must show battery voltageNOTE: If the meter shows no voltage, inspect bulb, fuses, wiring harness, connectors, and switches
TaillightBrakelight
The connector is the 3-prong one located under the rear fender assemblyVOLTAGE (Taillight)
NOTE: Perform this test on the main harness side of the connectorAlso, the ignition switch should be in the LIGHTS position
Fuel Solenoid
The fuel solenoid is used in conjunction with the ignition switch to control fuel flow from the lift pump to the unit injectorsThis enables the operator to shut off the engine quickly using the emergency stop switch or the ignition switchTo test the fuel solenoid, use the following procedure1On the multimeter, place the switch in the DC Volts position; then connect the black tester lead to suitable ground and the red tester lead to the fuel solenoid terminal