2011 Arctic Cat 700 Diesel SD Service Manual, Page 110Get this manual
10With the switch in the OFF position, connect the red tester lead to the red wire and the black tester lead to each of the remaining wiresThe meter must show an open circuit on all wires11Connect the red tester lead to the red wire and the black tester lead to the brown wireWith the switch in the ON position, the meter must show 980-1020 ohmsNOTE: If the meter shows more than ohm of resistance, troubleshoot or replace the switch component, the connector, or the switch wiring harness CD071
Ignition Switch
The connector is four-wire oneTo access the connector, the cover must be removedVOLTAGE
NOTE: Perform this test on the lower side of the connector
Handlebar Control Switches
The connector is the yellow one next to the steering postTo access the connector, the steering post cover and the right-side fender splash shield must be removed (see SteeringFrame)NOTE: These tests should be made on the top side of the connector