2011 Arctic Cat 700 Diesel SD Service Manual, Page 105Get this manual
6After charging the battery for the specified time, remove the battery charger and allow the battery to sit for 1-2 hours7Connect the multimeter and test the battery voltageThe meter should read at least 12.5 DC VoltsIf the voltage is as specified, the battery is ready for serviceNOTE: If voltage in step is below specifications, charge the battery an additional 1-5 hours; then retest Accessory Receptacle Connector
NOTE: This test procedure is for either the receptacle or the connector
VOLTAGE 1Turn the ignition switch to the ON position; then set the meter selector to the DC Voltage position2Connect the red tester lead to the redwhite wire or the positive connector; then connect the black tester lead to ground3The meter must show battery voltageNOTE: If the meter shows no battery voltage, troubleshoot the battery, fuse, receptacle, connector, or the main wiring harness
8Place the battery in the battery tray; then coat the battery posts and cable ends with light coat of multi-purpose grease
CAUTION
Before installing the battery, make sure the ignition switch is in the OFF position