2011 Arctic Cat 450XC Service Manual, Page 80Get this manual
RESISTANCE (Emergency Stop) 1Set the meter selector to the OHMS position2Connect the one lead to the brownlavender wire; then connect the other tester lead to the blackwhite wire3With the switch in the OFF position, the meter must show an open circuit4With the switch in the RUN position, the meter must show less than ohmKC276A
NOTE: If the meter shows more than ohm of resistance, replace the switch
1Turn the ignition switch to the ON position2Set the meter selector to the OHMS position3Connect either tester lead to pin B; then connect the other tester lead to pin A4The meter must show less than ohm5Turn the ignition switch to the LIGHTS positionThe meter must show less than ohm6Leaving the tester lead on pin B, connect the other tester lead to pin C7The meter must show less than ohmNOTE: If the meter shows more than ohm of resistance, replace the switch
RESISTANCE (Reverse Override)
NOTE: The handlebar control switch connectors are six pin and three pinBoth must be disconnected for this test